Reasons for low water pressure in the house. What to do?

The water pressure in a house can make a huge difference. It shows how fast dishes can be rinsed or the speed of water droplets in the shower.
With low water pressure, it is not easy to rinse the shampoo from hair or fill the bathtub. Contrary to popular belief, low water pressure doesn’t always mean big plumbing problems. Often, it can be fixed with the help of professional plumbers in Brentwood
Few reasons where you might experience the low water pressure in a house-
  • Check the main shut off valve
The water pressure increases if the main shut off valve is in the right position. It acts as a gateway for the water entering into the house. The water pressure decreases if it is not completely opened. If it is closed, the water will stop completely.
The valve can be located in the basement area or outside the wall of a utility area in the house. It is controlled by the wheel-like handle which needs to be turned counterclockwise. In the case of the lever handle, the pipe direction and handle must be parallel.
  • Water meter valve is fully opened
The water meter valve is also the main source of water that affects water pressure. It belongs to the city or area. 
You should not interfere with the water meter valve unless you need emergency plumber Brentwood. It is usually placed right by your water meter. The valve is opened if its handle is parallel with the supply line. The water alters if the handle is at some other angle. Contact the local water department if the water meter valve needs to be adjusted.
  • Problems with hot water heater
Hot water can affect water pressure for both hot and cold water. Few reasons for this-
  1. Hard water builds up: Many times minerals, sediments and rust accumulate in the water heater tank and pipes. This reduces the flow of water.
  2. Water heater valve: Water heater has a shut-off valve. The water pressure decreases if it is not fully opened or closed. 
A lot of pressure generates from the water heater which can be dangerous. Call the plumber for a repair.
  • Aerator screen is clogged
An aerator screen is the mesh screen which is at the end of the faucet. It controls the water that flows through tiny holes. Thus, it is used for water flow management and conservation.
The water pressure decreases if the faucet is clogged. You need to remove the aerator screen and soak it in hot water/vinegar. If the aerator gets damaged, then needs to be replaced.
  • Water pipes clog or corrode
The major reason for the low water pressure could be due to clogged or corroded pipes. The water will move around but the rate of flow will reduce based on the size of the clog. Clogs can burst the pipes if not cleaned on time.
Water pipes getting corroded are quite a common problem in older houses. This reduces the water pressure, gives bad taste while drinking and leads to discolouration of water. In the case of clog or corrosion, always call a plumber.
Installing a water pressure booster can be the best choice if water pressure is low due to leak or any other reason. It increases water pressure and improves the water flow.
Still, if the problem doesn’t solve, then call a plumber from Brentwood. Contact Q-tech that provides reputed, professional and well-trained plumbers at your convenience.

Comments

Popular posts from this blog

Benefits of standing wheelchair for disabled people

Importance of choosing a web design company in Bridgend

Importance of choosing a licensed electrician